Publicité
Les langues disponibles
Les langues disponibles
To attach the product to a
transportation vehicle
Attach the product during transportation to prevent
accidents and damage to the equipment. Use tie-down
straps to attach the product to the transportation vehicle.
1. Put the product on the transportation vehicle.
2. Attach tie-down straps around the product.
3. Attach and tighten tie-down straps to the
transportation vehicle.
To lift the product
WARNING:
equipment has the correct specification to
lift the product safely. The type plate on the
product shows the product weight.
WARNING:
or near a lifted product. Keep bystanders
away from the work area.
WARNING:
product. Make sure that the lifting eye is
correctly installed and not damaged.
2111 - 002 - 14.12.2023
Make sure that the lifting
Do not walk or stay below
Do not lift a damaged
1. Attach the lifting equipment at the lifting eye.
2. Lift the product safely. Hold the handle until the
product is lifted off the ground.
To disassemble the product
To move the product through small openings you can
disassemble the product.
1. Open the separator door and look if there is abrasive
material in the hopper. If there is abrasive material
in the hopper, empty it. Refer to
material from the hopper on page 20 .
2. Disconnect the product from the power supply.
3. Remove the dust collector hose.
4. Cut the cable ties that hold the power supply cables.
5. Disconnect the cables to the control panel.
To remove abrasive
27
Publicité
