Publicité
Les langues disponibles
Les langues disponibles
General product maintenance
Do a check of the brush list
seals and the front rubber seals
for wear.
Make sure that the nuts and
screws are tight.
Do a check of the V-belt ten-
sion.
Do a complete servicing and
cleaning of the product.
To clean the product
•
Always clean all the equipment after use. Use a
vacuum cleaner.
•
Do not use a high-pressure washer to clean the
product.
•
Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
To remove abrasive material from the
hopper
1. Start the product. Refer to
page 15 .
2. Push the ON button of the blast motor.
3. Push the OFF button of the blast motor when the
blast motor is at 75 % of maximum speed. At the
same time, open the valve for the abrasive material.
To operate the valve for the abrasive
Refer to
material on page 11 .
4. After 3 seconds, close the valve for the abrasive
material.
5. Operate the product 50 cm rearward.
6. Open the separator door and look if there is
remaining abrasive material. If there is remaining
abrasive material in the hopper, do the procedure
again until the hopper is empty.
To remove and install the hopper
1. Open the separator door and look if there is abrasive
material in the hopper. If there is abrasive material
in the hopper, empty it. Refer to
material from the hopper on page 20 .
2. Disconnect the power plug.
20
Each 3 h
To start the product on
To remove abrasive
12 h after
Daily
servicing
*
*
3. Loosen the clamp (A) on the abrasive valve.
4. Loosen the lever for the abrasive valve.
Each 3
months
X
A
2111 - 002 - 14.12.2023
Yearly
O
Publicité
