Husqvarna EBE 350 Manuel D'utilisation page 13

4. The second person puts a piece of wood (B) below
the front wheel. The dimensions of the piece of wood
must be 100×100×300 mm/4×4×12 inch.
B
5. While 1 person observes the process, the second
person installs the side seals in the side seal boxes:
a) Put the side seal (C) in the side seal box on 1
side of the product. Make sure that the rounded
part of the side seal points to the front of the
product.
C
2111 - 002 - 14.12.2023
b) Put the side seal holder (D) around the side seal
box to make sure that the side seal stays in the
correct position.
c) Install the side seal on the opposite side of the
product.
6. While 1 person slightly lifts the product up, the
second person removes the piece of wood.
7. The person that lifts the product upwards slowly
lowers the product onto the ground.
8. The second person removes the side seal holders
on both sides of the product (E).
Abrasive material
Speak to your Husqvarna dealer for the selection of
correct abrasive material for your surface operation.
Approved abrasive material on page 32 .
Refer to
D
E
13