Husqvarna EBE 350 Manuel D'utilisation page 18

8. Turn the control cage counterclockwise, if the
hotspot is too much on the left side.
9. Make sure that the hotspot is equally applied on the
surface for correct adjustment.
18
10. Make sure that the impeller (B) and the control cage
(C) are correctly installed in relation to eachother.
C
B
11. Tighten the cage clamps.
12. Use your hands to rotate the impeller and the blast
wheel. Make sure that there are no unusual sounds.
13. Install the hopper. Refer to
hopper on page 20 .
To stop the product
1. Close the valve for the abrasive material. Refer to
operate the valve for the abrasive material on page
11 .
2. Push the stop button for the blast motor (A), the fan
unit (B) and the drive motor (C).
3. Turn the ON/OFF switch to the OFF position.
4. Disconnect the power plug from the power supply.
5. Stop the dust collector. Refer to the operator's
manual of the dust collector.
C
B
To remove and install the
To
A
B
C
2111 - 002 - 14.12.2023