Publicité
Les langues disponibles
Les langues disponibles
3.1
120 V hard-wiring installation.
L1
N
L2
G
1. Insert Green or bare copper wire to the designated G Terminal. Tighten the screw.
2. Insert Neutral wire to the designated N Terminal. Tighten the screw.
3. Insert L1 wire to the designated L1 Terminal. Tighten the screw.
note:
If installing with Optional Wall mount Controller installation. Plug in the wire harness connection to the 4 pin
connector located next to the hard wire terminal block.
4. Make sure all connections are tightened properly.
5. Reinstall the junction box cover plate.
L1
BLACK/NOIR (L1)
N
WHITE/BLANC (N)
RED/ROUGE (L2)
G
GREEN/VERT (G)
electrical information
120 V
BLACK/NOIR (L1)
WHITE/BLANC (N)
GREEN/VERT (G)
W415-4173 / A-0 / 11.20.23
EN
25
Publicité
