2.0 installation
2.1
overview
WARNING
•
Risk of fire! The power cord must not be
pinched against a sharp edge. Secure cord to
avoid tripping or snagging to reduce the risk
of fire, electric shock, or personal injury. Do
not run cord under carpeting. Do not cover
cord with throw rugs, runners, or similar items.
Arrange the cord away from traffic areas to
prevent tripping.
•
Risk of fire! To prevent a possible fire, do not
block air intake or exhaust in any manner. Do
not use on soft surfaces where openings may
become blocked.
•
Risk of fire! Do not blow or place insulation
against the appliance.
•
This electric appliance is tested and listed
for use only with the approved optional
This appliance is designed as a Wall Mounted appliance
that can also be recessed into an enclosure. Select a
suitable location that is not susceptible to moisture and
note:
Follow all national and local electrical codes.
is away from drapes, furniture and high traffic areas.
Due to the many different materials used on different
walls, it is highly recommended that you consult your
local builder before you install this appliance.
This appliance Can be installed in multiple applications.
This appliance can be hung on the wall, partially in the
accessories. Use of optional accessories not
specifically tested for this electric appliance
could void the warranty and/or result in a
safety hazard.
•
Failure to follow these instructions exactly may
result in a fire or explosion, causing property
damage, personal injury, or death. Do not store
or use gasoline or other flammable vapors near
this or any other appliance.
•
This appliance is heavy. It is highly recommended
that two people install it for safety.
•
If your appliance is equipped with a heater,
ensure that the heater vents cannot be covered
in any way, as this may create a fire hazard.
wall, fully in the wall (single sided) at the end of a wall
(2 Sided) or in a bay "bump out" enclosure (3 Sided).
1. Select a location that is not prone to moisture
and is located at least 36" (91.4 cm) away from
combustible materials such as curtain drapes,
furniture, bedding, paper, etc.
2. The installation consists of 6 major steps, rough
framing, unit installation, hard-wiring, finishing
material, fireplace log media, then glass and trim
installation. Each step must be completed before
advancing to the next stage to achieve a seamless
installation and to avoid damaging the product
or enclosure.
W415-4173 / A-0 / 11.20.23
installation
EN
11