Publicité
Les langues disponibles
Les langues disponibles
2.3
wall mount installation
Due to the many different materials used on different
walls, it is highly recommended that you consult your
local builder before installing this appliance on the wall.
1. Select a location that is not prone to moisture
and is located at least 36" (91.4 cm) away from
combustible materials, such as curtains, drapes,
furniture, bedding, paper, etc.
2. Have two people hold the appliance against the
wall to determine its final location.
note:
It is strongly recommended that the mounting bracket be screwed into the wall studs where possible. If the
wall studs cannot be used, ensure that the supplied plastic anchors are used to affix the bracket to the wall
and that the bracket is adequately secured.
5. With the wall-mounting bracket installed, have two
people lift the appliance up and insert the hooks
on the bracket into the slots on the back of the
appliance (Fig. 3).
Wall
3. Place the appliance face down on a soft, non-
abrasive surface. Remove the bracket from the
back of the appliance by removing the screws
(Fig. 1). Set the bracket aside and discard
the screws
4. Mark out the location, then mount the bracket
onto the wall using screws (supplied). This bracket
MUST have the hooks facing upward and it MUST
be level (Fig. 2).
Wall
Fig. 1
6. Install the MDF bracket (supplied) to the bottom of
the appliance by removing the unpainted existing
screw in the centre of the appliance and then
reinstalling it with the MDF bracket (Fig. 4).
Wall
Fig. 3
installation
x6
Fig. 2
MDF
Bracket
Fig. 4
15
W415-4173 / A-0 / 11.20.23
EN
Publicité
