Bosch CRS 845H Guide D'installation page 33

2. Affix the hinge bolts (Fig. 9, item 3) (2 pcs) to the
side panel (Fig. 9, item 2) using the spacer plate
(Fig. 9, item 1) und countersunk bolt.
3. Attach the mounting bracket (Fig. 9, item 5) using a
hexagon nut.
4. Insert the plug sockets (Fig. 9, item 6) (4 pcs) into
the holes.
i
When routing the cables, the sensor leads can be
affixed to the plug sockets using cable ties.
5. Insert the rubber buffers (Fig. 9, item 4) (2 pcs) into
the designated holes. To do so, lightly coat the rub-
ber buffers with test oil.
6. Secure the bolts (Fig. 9, item 7) (1 pcs) using a
hexagon socket head bolt M5 x 10 and washer.
5
4
4
Fig. 9: Assembly of hinge bolts, plug sockets and rubber buffers
7. Repeat steps 2 to 6 with the second side panel.
Robert Bosch GmbH
1
2
3
7
Installation | CRS 845H | 33
8. Attach the base (Fig. 10, item 1) to both side panels
(see Fig. 10 and Fig. 11) using four hexagon socket
head bolts and washers.
9. Fully tighten the screw-in base (Fig. 10, item 2).
1
2
Fig. 10: Assembly of left side panel
2
Fig. 11: Assembly of right side panel
en
1
|
1 689 978 535 2014-10-21