KitchenAid Architect Serie Guide D'installation page 26

2. Remove the locking plate as shown. 3. Replace the door stop screw in the bottom hinge and tighten.
IMPORTANT: Do not place the door stop screw in the 130°
position on Overlay Series models. See "Handle and Door
Clearances."
3. Turn the bushing located underneath the bottom of the hinge
using a 4%" open-end wrench. Turning the bushing to the left
will lower the door. Turning the bushing right will raise the
door.
4. After adjusting, check the doors to make sure they are even at
the top and bottom. If the doors are not even, continue to turn A. 130°
the bushing to adjust the door. B. 110° (Overlay series)
5. Replace the locking plate. . 90°
mg Turn the bushing slightly to align the hinge and locking 1
plate screw holes. 42" (106.7 cm) Models
' ' 1. Check that the refrigerator door can open freely. If the door
m Replace and tighten the locking plate screw. opens too wide, you will have to adjust the door stop position.
6. Make final check to make sure the doors are aligned and 2. Grasp both ends of the top grille.
: 3. Push the top grille straight up, then pull straight out. Lay the
Door Swing Adjustment grille on a soft surface.
36" (91.4 cm) Models
1. Check that the refrigerator door can open freely. If the door
opens too wide, remove the door stop screw from the bottom
hinge with a Torx®t T15 screwdriver.
A. Top grille
B. Cabinet side trims
4. The door stop is located on the top hinge.
~~"
A %
ESL
A. Door stop screw "A"
B. Door stop screw "B"
C. Door stop
T®TORX is a registered trademark of Saturn Fasteners, Inc.
26