KitchenAid Architect Serie Guide D'installation page 18

Side Trim
YA" —
(6.35 mm) =<
Weg"
(4.5 mm)
Sig"
(4.7 mm)
Tag"
(5.5 mm)
rt
1349" (10 mm) Gs 7 mm)
Inset Installation Dimensions
Recessed Inset Installation Dimensions
1. Measure the distance from point A (as shown) to back wall.
2. Rout the front edge of the support board or attach a 1%"
(6.35 mm) board to hold the panel in the cabinet side trim.
ere
PES,
Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed and the end of a cabinet run. You
may choose an Inset or Recessed Inset panel installation.
1. Measure the distance from point A (as shown) to the back
wall. Add "2" (5.6 mm) to this measurement to allow the side
panel to fit into the trim.
2. If the panel is more than 14" (6.35 mm) thick, rout the front
edge to allow the side panel to fit into the trim.
Flush Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall.
2. Attach the support board with a screw or adhesive that is
compatible with aluminum and wood.
18
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type of
installation you are planning.
NOTES:
m Thedimensions shown are actual product dimensions and
may not reflect the needed installation dimensions.
m_ Theside panel should be a minimum of 1%" (1.27 cm) thick
to avoid warping.
m_ If the opening depth is 25" (63.5 cm) or more, you may
want to install a support board on the rear wall.
Refrigerator (36" [91.4 cm] Models)
Overlay
231/46"
(60.16 cm)
LAT k