KitchenAid Architect Serie Guide D'installation page 25

4. Reinstall the trims and corner caps. 5. Replace the top grille in the cabinet side trims and pull the
5. Remove the film from the screw covers. Snap the screw panel down slightly to lock it into place.
B
|
covers into the handle trim section.
1. Loosen, but do not remove, the four Torx®' 27 flat-head
mounting screws and the two %" hex-head mounting screws
in the top hinge.
B
i
: Adjust the top hinge of the door to align it.
| 3. Tighten the Torx® 27 flat-head mounting screws to a torque of
A. Top grille
B. Cabinet side trims
1. Grasp both ends of the top grille.
7 ul
2. Push straight up; then pull straight out. Place the top grille Door Alignment (36" [91.4 cm] Models)
panel-side down on a soft working surface.
approximately 100 inch-pounds (11.3 Nm).
4. Tighten the 14" hex-head screws.
A. Top grille
B. Cabinet side trims
3. Remove one end cap by loosening the nuts and sliding the
end cap off.
A. Torx®' 27 flat-head mounting screws
B. 4" hex-head mounting screws
Door Height Adjustment (42" [106.7 cm] Models)
A. Bottom rail C. End cap Use the following steps to adjust the door height, up or down,
B. Nuts D. Top rail after the refrigerator has been leveled.
NOTE: Adjust the right door to the position of the left door first. If
it is necessary to adjust the left door, you must make sure that the
hinged center rail located on the left-hand door does not drag
when closing the door.
1. Open the freezer drawer. Remove the locking plate screw from
the bottom side of the refrigerator door hinge using a
Y4" open-end wrench.
4. Slide the custom panel into the top grille channel and reattach
the end cap.
:
i
i
A. Custom panel
A. Bushing
B. Locking plate
C. Locking plate screw
25