Install Base Grille
There are two pieces to the base grille to allow for a custom fit: the
base grille itself and the skirt. The skirt can be added to the base
grille in order to extend it all the way to the floor.
1.
To see whether the skirt is needed, place the base grille into
position. Do not attach the base grille to the refrigerator.
Measure the distance between the bottom of the base grille
and the floor. The gap must be a minimum of ¥%" (1.27 cm) in
order to add the skirt.
NOTE: If the gap measures less than %" (1.27 cm), skip
steps 3 and 4 of the instructions, and install the base grille
only.
Remove the film from the base grille.
3.
Snap the skirt onto the base grille.
A. Base grille
B. Skirt
4.
Trim the skirt by scoring the proper "V" groove with a
utility
knife. Break the skirt at the score line.
A. "V" groove
5.
Using the two screws, attach the base grille assembly to the
refrigerator as shown.
NOTE: Drive in the right side screw first.
A. Screws (2)
28
Turn the water supply line valve to the "Open"
position.
2.
Turn the refrigerator switch to the ON position. See "Power
On/Off Switch" in the Use & Care Guide for instructions. Wait
a few minutes. Check the water line connections for leaks.
3.
Remove all boxes, parts packages and packing materials from
the interior of the refrigerator. See the "Cleaning" section in
the Use & Care Guide for instructions. Remove the film and
cardboard from the grille and doors or door frame, depending
on your model.
4.
Install the shelves and bins in the refrigerator and freezer
compartments.
5.
The controls are preset at the factory to the midpoint setting.
Make sure the compressor is operating properly and that all
the lights are working.
6.
If construction will continue after the refrigerator has been
installed, set the controls to OFF.
To get the most efficient use from your new built-in refrigerator,
read the Use & Care Guide. Keep Installation Instructions and Use
& Care Guide near the built-in refrigerator for easy reference.