Publicité
INSPECTION OF BLADE INSTAllATION
CONTROlE DE lA FIXATION DE lAME
Couple de serrage (kg/em)
1. Fermer le robinet d'essence. (5)
2. Debrancher la bougie
3. Incliner la machine sur le cote droit.
4. Verifier le couple de serrage des bou-
Ions de fixation de lame et les resserrer
si necessaire,
A
Attention:
- Pourcontroler
l'
etatdelalame, veiller
a
arreterprealablementle moteuret
Ii
debrancherlefll de bougie.
- Porterdes gants epais.
- Ne pas incliner
la
tondeuse du cote
gauche (cote du carburateur), pour
evlterlesfuites de carburant.
(
450 - 550
550 - 640
Type E:
Type B:
Tightening torque [kgf'em (ft-lbs)]:
Type B:
550 - 640 (39.8 - 46.3)
Type E:
450-550(32.5-39.8)
A
Caution:
- Before inspectingthe blade, stop the
engineand removethe sparkplug cap
topreventthe enginestartingacciden-
tally.
- Wearthickgloves wheninspectingthe
blade.
- Be sure to tilt the machine only on its
right-handsideto keepthe carburetor
side up, or difficult engine start will
result.
-lffuelshouldbespilt, wipeupthe spilt
fuel atonceand waituntilit evaporates
completely beforestartingthe engine.
1. Turn the fuel cock to the CLOSE posi-
tion (5).
2. Remove the spark plug cap.
3. Tilt the machine on its right-hand side
as illustrated.
4. Check the blade tightening bolts for
tightness. Re-tighten them to the
specified torque if necessary.
Type E
Type B
ADJUSTMENT OF THE HANDLE BAR
HEIGHT
1. Loosen the handlebar support tighten-
ing bolts and nuts at both sides.
2. Loosen the handlebar tightening nuts
on both sides.
3. Remove the handlebar tightening bolts
which have square necks.
Reset the handle bar to the required
height and re-install the bolts. The han-
dle bar height can be adjusted in three
steps.
4. Re-tighten the bolts and nuts securely
both for the handlebar and its supports.
REGlAGE DE lA HAUTEUR
DU GUIDON
1. Desserrer les boulons de fixation des
renforts de guidon de chaque cote.
2. Desserrer les molettes de fixation de
guidon des 2 cotes de la machine.
3. Oter les boulons it collet carre. Posi-
tionner le guidon it la hauteur desiree et
remettre les boulons en place. II existe
trois positions possibles de hauteur de
guidon.
4. Rebloquer les boulons de fixation du
guidon sur les renforts.
(
-22-
Publicité
