ISE SY-T2802 Manuel D'utilisation page 33

▲ First set speed at lowest position.
▲ Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6mm Hex-
agonal Wrench, until the belt is centered itself; If belt shifts to left, tighten the left bolt
and loosen the right bolt by using 6mm Hexagonal Wrench, until the belt is centered.
When adjusting the belt using the 6 mm Hexagonal Wrenches, it is important to adjust the
belt in half turn increments. Over adjusting the belt can cause damage to the mat.
This treadmill is designed in a way that in the event of an electrical fault, the machine will
turn off automatically to prevent any injuries to the user and to prevent damage to the
machine (i.e. motor).
When the treadmill behaves erratically, simply reset the treadmill by turning the power
switch off, waiting for 1 minute then turning the power button back on.
1. Alarm signals
E02 Over voltage protection of motor
1.Make the machine self-checking again
2..Change controller
E03 Over current protection
1.Clean the dust between running board and belt, then put some oil
2.If the running belt wear seriously, please change the running belt
E04 Motor open circuit
1.Check the check the connect wire of motor ,if the connect wire loose, please connect it
again.
2.The motor carbon brush wear, replace carbon brush or motor
E05 EEPROM damage or access problems change the controller board
E06 Communication error
1.Check the connect wire between computer and controller board, if it loose or broken,
please connect it again or change it
2.change the incline motor
E09 short-circuit protection change the controller board
"－"safety key not connected
insert the safety key
No Power
1. Check fuses (They are located on the controller under the motor cover )
2. Check power outlet (Plug something else into the power outlet to ensure that the
power outlet is working correctly).
3. Check Power Cable (You may need to take it to an electrician).
TROUBLE SHOOTING
13
EN