ISE SY-T2802 Manuel D'utilisation page 22

19. The pulse sensor is not a medical device. Various factors, including your movement, may affect
the accuracy of heart rate readings. The pulse sensor is intended only as an exercise aid in deter-
mining heart rate trends in general.
20. Do not attempt to raise, lower, or move the treadmill until it is properly assembled. You must be
able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.
21. When folding or moving the treadmill, make sure that the storage latch is holding the frame
securely in the storage position.
22. Do not change the incline of the treadmill by placing objects under the treadmill.
23. Inspect and properly tighten all parts of the treadmill regularly.
24. Never drop or insert any object into any opening on the treadmill.
25. DANGER: Always unplug the power cord immediately after use, before cleaning the treadmill,
and before performing the maintenance and adjustment procedures described in this manual. Never
remove the motor hood unless instructed to do so by an authorized service representative. Servicing
other than the procedures in this manual should be performed by an authorized service
representative only.
26. This treadmill is intended for in-home use only. Do not use this treadmill in any commercial,
rental, or institutional setting.
27. WARNING:
If the supply cord is damaged, it must be replaced by the manufacturer,its service agent or similarly
qualified persons in order to avoid a hazard.This appliance is not intended for use by persons
EN
(including children) with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use of the appliance
by a person responsible for their safety. children should be supervised to ensure that they do not
play with the appliance.
28. Install the treadmill on a flat level surface with a suitable volt/Hz which marked in the machine
label, grounded outlet.
29. Allowed temperature: 5 to 40 degrees. If the treadmill has been exposed to cold tempera-
tures,allow it to warm to room temperature before turning on the power.If you do not do this, you
may damage the console displays or other electrical components.
2