EUROM 350319 Manuel D'utilisation page 38

•
Press the function button
The display will show Fig. B.
•
Press the button again and the heating will switch to full power. The
display will show Fig. C.
•
Press the function button a third time and the unit will return to mode
A.
•
The timer button
the timer button on the unit.
Set the day and time:
•
Make sure that the unit is in standby mode (S) (use the main switch).
You can also set the day and time while the unit is switched on.
•
Press the SET button
plus and minus buttons
SET again to see the minutes. The display shows "30" and you can use
the plus and minus buttons to set the number of minutes, from 00 to
59.
• Press SET again and the display will show
buttons to set the day: Monday = d1, Tuesday = d2, etc.
• Finally, press
mode it was in before you set the day and time. Press SET to check the
day and time.
Set the temperature:
•
Make sure the unit is switched on then press the plus or minus button; the standard
setting is "23". Press the plus or minus button until you have reached the required
temperature (between 10°C and 35°C). Press OK to confirm the setting. The display
shows the set temperature and the power, for example:
•
If you have set the temperature, the unit selects the power required: full power if it
needs to heat the room by more than 2 °C and low power if it needs to heat the room
by less than 2 °C. Once the unit has reached the set temperature,
the heating element is switched off but the ventilator remains
switched on for another 3 minutes. This circulates the air in the
room so that the unit can sense whether the room is cooling down.
The unit returns to standby after 3 minutes. The unit switches on
again if the room cools down to 2 °C below the set temperature.
•
To turn the thermostat off, press the function button
heating on low or full power. The unit will now work continuously.
You no longer see the temperature on the display, which shows Fig.
B or Fig. C. If the unit has been running continuously for 12 hours, it
will switch off automatically, cool down and return to standby.
to switch the heating on, on low power.
on the remote control works in the same way as
once; the display now shows "12". Use the
/
to confirm the settings. The display will return to the
to set the hour (from 0 to 23). Press
; use the plus and minus
38
and select