Publicité
Les langues disponibles
Les langues disponibles
heater downwards.
•
Attach the heater using the materials supplied (see diagram). Place the bracket on top
of the heater with the short side against the wall. Mark the location of the hole on the
wall and remove the heater. Drill a hole at the marked spot and insert a plug. Now
hang the heater in place and screw the bracket to the wall, as shown in the diagram.
The heater is now installed.
Set-up and Operation
•
Make sure that the main switch is OFF (O)
•
Unroll the electrical cable entirely and insert the plug into a suitable
220/240V socket.
•
Set the main switch to ON (l). The display will show "S" (standby).
Manual operation using the buttons:
•
Press the F button once. The ventilator will switch on and the display will show Fig. A.
•
Press the button again and the heating will switch on, on low power. The display will
show Fig. B.
•
Press the button a third time and the heating will switch to full power. The display will
show Fig. C.
•
Press the button a fourthtime and the unit returns to standby (S). The unit will cool
down for 3 minutes.
•
You can set a delayed start time using the timer button
and press the timer button, this will be visible on the unit. Each time you press the
timer button, one hour is added to the start time. The display shows the number of
hours set and counts down at the end of each hour. The timer lamp also switches on.
The unit starts automatically at the end of the set time. The standard temperature is
23°C (note it is not possible to set the
thermostat using the buttons).
•
If the weekly programme is not set and if no
temperature has been set using the remote
control, the unit will switch off automatically
after 12 hours.
Operation using the remote control:
Please note: the remote control only works if the emitter on the remote control can make
contact with the receiver on the unit.
•
Make sure that the unit is in standby mode (S) (use the main switch).
•
Press the power button
to switch the ventilator on; the display will show Fig. A.
37
. Set the unit to standby (S)
Publicité
