EUROM 350319 Manuel D'utilisation page 36

recognised electrician to be checked and/or repaired. Always ask for original parts to
be used.
4. The device may only be opened and/or repaired by a competent and qualified
person. Do not carry our your own repairs as this could be dangerous! Repairs carried
out by unauthorised persons or changes made to the device could damage the
dust/waterproof capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the manufacturer, their
service department or somebody with similar qualifications in order to prevent
creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or personal injury. They
will invalidate the guarantee and the supplier, importer and/or manufacturer shall not be
liable for the consequences.
Description
1. Main switch
2. Display
3. Function selector
4. Timer button
5. Suction grille (back)
6. Outlet grille (bottom)
Location and connection
•
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
•
Select a suitable location for the device taking into account all the aforementioned
warnings in this manual.
The heater has to preferably (and definitely in damp rooms) be positioned at and
permanently connected to an electric socket. This connection may only be made by a
qualified electrician and, for that reason, is not described here.
In this manual, for reasons of safety, use with a plug should be assumed; when there is
a permanent connection, any passages about the plug do
not apply.
•
Drill 2 holes (8 mm.) in the wall at the selected spot:
horizontal to one another with a distance of 18,7 cm.
Insert plugs into the holes and insert screws into the
plugs (included). Leave the screws protruding by 5 mm.
Hook the heater using the suspension eyes over the
screws, slide it as far as possible to the left and pull the
36