Melitta Caffeo Lattea Guide D'utilisation page 78

Problem
Symbol for the
milk shower
illuminated out of
sequence.
The cleaning or
descaling process
was interrupted.
The brewing unit
can no longer be
reinserted after
removal.
Continuous flashing
of all buttons
Please contact the Melitta
solve the problem: +49 571/ 86 1900.
76
Heft_Lattea_EU_2_3.indd 76
Cause
There is air in the lines
is inside the appliance.
The power supply was
interrupted, e.g. due to a
power outage.
The brewing unit is not
properly locked.
The actuator is not in the
proper position.
System error
hotline, if the above mentioned solutions do not help to
®
Solution
Open the valve until the symbol
goes out and close the valve
again. Switch off the appliance
and remove the brewing unit,
clean under running water,
and then reinsert it. Switch
the appliance back on again.
Subsequently, dispense a
larger amount of coffee.
The appliance performs a
rinsing program autonomously.
To do so, follow the appliance
instructions.
Check whether the handle
for locking the brewing unit is
correctly engaged.
Switch the appliance off and
on again, and then press
simultaneously the buttons for
one- and two-cup dispensing
for longer than 2
seconds. The actuator moves
into position. Then reinsert the
brewing unit and make sure it
is correctly locked into place.
Switch off the appliance and
switch it on again via the ON/
OFF button ; if this does
not solve the problem, send in
the appliance to be serviced.
09.04.2014 14:04:24