Renfert Basic classic Traduction Du Mode D'emploi D'origine page 21

4.3 Compressed air connection
⇒ Push the compressed air tube (22) onto the tube connection
point (12) as far as it will go� In doing so there will be a slight
resistance to overcome�
⇒ To connect to the compressed air system, select the relevant
tube coupling from the supplied set and attach this to the other
end of the tube�
⇒ Connect to the compressed air network�
4.4 Electrical connection
Note the instructions in Chap. 2.6 Risk as a result of electric
shock and fire!
⇒ Plug the mains cable (23) into the socket (4)�
⇒ Plug in the mains cable�
4.5 Connection to suction device
⇒ Plug the suction tube from the extraction unit to the suction
pipe (18)�
⇒ For suction devices with automatic activation: connect the mains
plug from the sandblasting unit into the user socket on the suc-
tion device�
4.6 Adjusting the Operating Pressure
⇒ Activate the foot switch�
⇒ Set the sandblasting pressure (1 - 6 bar / 14�5 - 87 psi) at the
pressure regulator (7)�
♦ The amount of pressure will be shown on the pressure
gauge (8)�
In the 2 tank version the amount of pressure selected applies for
both blasting tanks�
4.7 Filling the Sandblasting Tanks
Do not write on or stick anything to the sandblasting tank and
tank lid.
Do not press the foot switch while filling is in progress!
Regardless of the pressure display, the sandblasting tanks
are only pressurized when the foot switch is pressed.
⇒ Only fill with abrasives up to the max. fill height (thickening of the
tank cover underneath the thread)�
⇒ Clean the thread on the sandblasting tank and tank lid as well as
the seal�
⇒ Screw the tank lid closed firmly by hand.
- 7 -
23
18
7
8
max.
en
12
22
Fig. 3
4
Fig. 4
Fig. 5
Fig. 6
Fig. 7