Manual Operation; Empty Sweeping Container - Wetrok Master Sweep 97 Plus Manuel D'utilisation Original

3. Switch the sweeping machine on by switching
the on/off switch to the I position.
4. Check whether the device is working again as
usual.

7.6 Manual operation

When the battery is low, the sweeping machine
can be used temporarily without a power supply.
The sweeping mechanism is activated by pushing
the machine forward.
• Use both hands to push the device with the
push bar.
• Push the device forward at normal walking
speed.
• Empty the sweeping container as needed.
See Section "Empty sweeping container" in
Chapter 7.7 of this operating manual.
• Fully charge the battery again as needed. See
Section "Charging battery" in Chapter 6.3 of
this operating manual.
» Only use manual operation temporarily.
Results are better under battery operation and
use a very small amount of power.

7.7 Empty sweeping container

WARNING
Risk of cutting due to broken glass, metal
or other sharp edged materials!
When emptying the sweeping container,
cutting injuries may occur due to broken glass,
metal or other sharp edged materials.
• Wear the prescribed personal protective
equipment!
CAUTION
Risk to health from dust from sweeping
container!
There is a risk to health from dust collected
when the sweeping container is emptied.
• Wear the prescribed personal protective
equipment!
Fig. 17: Empty the sweeping container
• Empty the sweeping container after each use.
• Empty the sweeping container at regular
intervals to achieve a proper sweeping result.
1. Bring the push bar (1) to the forward position.
2. Pull the sweeping container (3) upwards by
the container handle (2).
3. Empty the sweeping container (3) completely.
» Make sure that the enclosure sides are free
of dirt.
4. Insert the empty sweeping container (3) on the
device.
5. Press the container handle (2) back into the
starting position.
» The sweeping container (3) must audibly lock
into position.
6. Bring the push bar (1) back into the operating
position.
Operation
EN
51