Commissioning; Install Push Bar; Connect Battery Leads - Wetrok Master Sweep 97 Plus Manuel D'utilisation Original

6. Commissioning

6.1 Install push bar

CAUTION
Risk of injury through tipping over of the
push bar!
Tipping over of the push bar may lead to slight
injuries, such as jamming of the finger or
bruising in users or other persons.
• When carrying the device, hold it so that the
push bar cannot tip over.
The push bar can be adjusted to the height of the
user in two levels (A) and (B).
» (A): Lower level
» (B): Upper level
A
2
3
1
Fig. 8: Push bar assembly
1. Turn the handles (1) into the vertical position.
2. Press the locking springs (3) inwards on both
sides of the push bar.
B
2
3
1
3. Push the push bar (2) into both handle fittings
simultaneously.
» To do so, the push bar must be pulled apart
about 10 cm before insertion in the handle
fittings.
4. Push the push bar (2) into the handle fittings
until the locking springs lock in.

6.2 Connect battery leads

2
1
1
Fig. 9: Open the cover
CAUTION
Risk of injury from unintentional starting of
the sweeping machine.
When the battery lead is connected there
is a danger of items being pulled into the
machine due to the unintentional starting of
the sweeping machine.
• Before the battery is connected ensure
that the position of the on/off switch is in 0
position.
» Upon delivery and for storage times of 2
months or more, the blue battery lead should
be removed from the insertion flap to prevent
the battery losing its charge.
1. Pull the two flaps (1) on the front underside of
the cover (2) a short distance forwards.
2. Lift the cover (2)
Commissioning
EN
45