Operation / Adjustment - Wetrok Turbo Sweep 770 Plus Manuel D'utilisation

Turbo Sweep 770 Plus
Dear Costumers,
We are happy that you chose a quality product from the Wetrok company.
The TURBO SWEEP 770 system is an especially efficient hand sweeping machine that is simple to operate and that can be used for all even and hard
surfaces. The unique Turbo- sweeping system with circular brushes and sweeping rolls guarantees double cleanliness. The flatly operating circular
brushes collect all kinds of road dirt, from fine dust to wet leaves, empty cans, and even heavy garbage. The sweeping rolls collect fine dust and, in
addition, ensure the optimal overhead filling of the dirt container.
In order to guarantee a long service life of your sweeping machine, the following operating instructions must be observed.
ASSEMBLY OF THE SLIDING FRAME
Push the catch spring of the sliding handle (item 7.12) and connect the sliding frame (item 7.11) with the handle fittings (item 7.13) by engaging the
catch spring. Connect the sliding frame with the sweeping machine by lightly tapping the handle fittings. To remove the sliding frame, press down on the
catch spring located on the inside of the handle fittings (item 7.13) with a big screwdriver and remove the sliding frame in an outward direction.

OPERATION / ADJUSTMENT

The TURBO SWEEP 770 sweeping machine is factory preset for even surfaces. The brush pressure is continously adjustable by means of the adjusting
button (item 1.11). Step 1-2: new brushes for all even floors Step 3-4: new brushes for wet leaves, sand, uneven floors (e.g. exposed aggregate con-
crete) Step 5-8: older brushes for readjustment of the worn brush parts.
Please ensure that the brushes rest on the floor with light pressure only. Deeper adjustments do not bring about better cleaning results and
may increase the wear.
Push the sweeping machine with normal speed and lift the sliding handle a little bit. The protruding circular brushes will sweep all the corners, too. To
sweep over small steps (2-3 cm) slightly press down the sliding handle.
STORAGE (FIG 1)
The best way to store the TURBO SWEEP 770 sweeping machine is in the vertical position and can be best accomplished by placing the unit on the
backside of the bin or by suspending it with the sliding frame (top side of the machine in direction to the wall).
EMPTYING
To open the dirt bin, pull the bin handle (item 6.05) upward. After removing and emptying the bin, replace it and lock it by pushing down the bin handle.
MAINTENANCE
You chose a product that is easy to maintain. The circular brushes, the sweeping rolls and the drive system are to be cleaned with water. All the bearings
are dust-proof. Please do not use highpressure cleaners.
In order to guarantee an easy and wear-resistant operation, the brush drives Pos. 4.03 + 3.0 could be sprayed with the original lubricant
spray from time to time. Do not use other oils or grease.
14
• EN