Set Up And Assembly; Ameda Hygienikit Milk Collection System; Before Every Use; Operating The Pump - Ameda Elite Instructions

Set Up and Assembly

Ameda HygieniKit Milk Collection System

Before Every Use

Always wash hands well with soap and water before
handling the Ameda Elite Breast Pump and Ameda
HygieniKit Milk Collection System.
IMPORTANT NOTE: ONLY USE THE AMEDA HYGIENIKIT
MILK COLLECTION SYSTEM ON AMEDA ELECTRIC BREAST
PUMPS.
Prior to starting pump, assemble and connect the Ameda
HygieniKit Milk Collection System, per included instructions.
If the Ameda HygieniKit Milk Collection System is sterile, use
as is. If not sterile, see the Ameda HygieniKit Milk Collection
System cleaning instructions.
5
The Ameda HygieniKit Milk Collection System can be used to
single or dual pump.
To single pump:
Remove one tube and
close tubing adapter.
6
E N G L I S H
Adapter Cap
2
Silicone Diaphragm
1
Breast Flange
3
4
Milk Bottle
Tubing Adapter
To dual pump:
Both tubes should be
attached to tubing
adapter.
Elite with Detachable Power
Cord
• Attach Ameda supplied
power cord to AC power
inlet on rear of pump.
• Connect power cord to wall
outlet.
Elite with Built-in Power
Cord
• Connect power cord to wall
outlet.

Operating the Pump

Valve
Tubing
off, insert a finger between breast(s) and breast flange(s)
to break suction, remove breast flange(s) from breast(s).
Discontinue pumping and contact a healthcare provider.
faster. When milk flow slows, turn the 'CYCLES' dial all the
way to the right to help start another (let-down). Repeat as
milk flow changes to pump more milk.
Removing Ameda HygieniKit Milk Collection System
from Breast(s)
• After pump is switched off, if necessary, insert a finger
between breast(s) and breast flange(s) to break suction.
• Remove breast flange(s) from breast(s).
• Insert tubing adapter into
tubing adapter port on
piston/cylinder.
• Center nipple(s) in breast
flange(s) and fill breast
flange(s) with the breast(s)
to create an air seal.
• Turn the pump ON by turning
the 'VACUUM' dial to the
right.

Setting Suction

• Increase the suction by
turning the 'VACUUM' dial to
the right. Increase suction
until reaching maximum
comfort level.
• If discomfort is felt in nipple(s)
or breast(s), decrease suction.
If discomfort is felt at all
suction settings, turn pump

Setting Speed

• Start with the 'CYCLES' dial
all the way to the right to
increase the speed and
trigger a milk ejection reflex
(let-down)
• When milk flows, (let-down)
turn the 'CYCLES' dial to the
left to slow down the speed
to help drain the breast

Turning Pump OFF

• When finished pumping, turn
the 'VACUUM' dial all the
way to the left to turn the
pump off.