Ameda One-Hand Manual Breast Pump; Set Up; Before First Use; After Every Use - Ameda Ultra Mode D'emploi

Ameda One-Hand Manual Breast Pump

Note: One-Hand Handle Assembly included with some versions. Also sold separately.

Set Up

ALWAYS WASH HANDS WELL WITH SOAP AND WATER BEFORE PUMPING.

Before First Use

After Every Use

1. Take apart One-
Hand Manual
Breast Pump.
Unscrew bottle
from breast flange.
5. Peel off piston seal
from piston.
Large plastic pieces (breast flanges, handle, and bottles) can be washed on the upper rack
of a standard household dishwasher. Wash piston, piston seal and white valve gently by hand.
Do not insert anything into white valve while cleaning.
10
E N G L I S H
If your One-Hand Manual Breast Pump is marked "STERILE," open
and use.
If your One-Hand Manual Breast Pump is NOT marked "STERILE," before
first use:
• Boil all parts for 20 minutes.
• Remove all parts from water right after boiling.
• Allow parts to air dry before assembly and use.
2. Slide handle bottom
off breast flange.
6. Pull off white valve
from breast flange.
Note: Grasp white
valve gently by
thick sides, not
by thin edge to
prevent damage.
3. Remove piston
from upper
chamber.
7. Rinse any milk
residue from pump
parts with cool
water.
Wash all parts
in warm, soapy
water.
Rinse well in warm,
clean water.
4. Push down
on handle to
release piston.
8. Allow parts to
air dry on clean
surface.