Melitta CAFFEO PASSIONE Manuel D'instructions page 95

Requirement: The appliance is ready for operation. 0.5 litres of descaling
solution has been prepared and is ready for use.
Symbol on the Displays
selector switch
or buttons
Steps
1. Press the "Service" button and also the
"Steam dispensing" button for longer
than 2 seconds.
» The appliance indicates that:
ū the descaling program is run-
ning
ū the first programme stage is
reached
ū the drip tray and the coffee
grounds container must be
emptied.
2. Empty the drip tray and the coffee
grounds container (see section 4.8
Emptying the drip tray and coffee
grounds container on page 76).
3. Turn the selector switch until the set-
ting for hot water points upward.
4. Insert the drip tray without the coffee
grounds container.
» The appliance indicates that:
ū the second programme stage is
reached
ū the water tank must be filled.
ū Descaling fluid must be filled
into the water tank.
5. Place the coffee grounds container
beneath the Cappuccinatore.
6. Open the lid of the water tank and
pull the water tank upwards out of the
appliance by the handle.
7. Fill 0.5 litres of descaling fluid into the
water tank. Observe the correspond-
ing instructions for use of the fully
automatic coffee maker descaling
agent.
Care and maintenance
95