Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SETTING UP YOUR BREWER
PRIMING YOUR BREWER
Beverages cannot be brewed until the Brewer has been primed. The priming cycle fills the boiler
with water and flushes the system through. After this your Brewer will be ready for use.
Step 1: Plug the Brewer into the AC outlet.
Step 2: Remove the Drip Tray from the Brewer
and place a large container of at least
70 floz (2.0L) under the drinks dispense area.
The height of the Brew Head height can be
adjusted if necessary by pressing the button
on the side of the Brew Head and sliding it up
or down.
Step 3: Press and hold down the 'HOT CHOCOLATE' and
'HOT WATER' selection buttons
Step 4: While continuing to hold down the two buttons
set the switch on the back of the Brewer to the 'ON'
position.
Step 5: When the indicator lights of the two buttons being held illuminate,
release them and the 'HOT WATER' indicator light will illuminate.
If these steps are completed successfully the 'Hot Water' indicator light will
now be on steadily. The Brewer is now ready to begin the PRIME cycle.
Step 6: Now Press the 'HOT WATER' button to begin the PRIME cycle.
Note:
Priming can be paused and resumed by pressing the 'HOT WATER' button.
The Brewer will start to pump water, and the 'Hot Water' indicator light will flash slowly. After several
seconds water will be dispensed into the container. The water jet may be seen to 'splutter' for a short
while at the start, this is normal.
The Brewer will automatically stop pumping after about 2 minutes after which the Prime cycle is
complete. The Brewer will pump approximately 60 fl oz (1.7L) of water into the collecting container.
The system is now primed and will begin to heat the water. While the water is heating, all this
indicator lights will flash slowly. When complete all the indicator lights will be on steadily.
Your Brewer is now ready to start making drinks.
Note:
The priming cycle will be paused if the machine detects that a freshpack is inserted, the Pack Door
is opened or the water level is low. Ensure that the Pack Door is closed and no freshpack is present
and the Cold Tank is filled with COLD water. Resume the priming cycle by pressing the 'Hot Water'
button.
If brewer is switched off before the prime cycle is completed the entire process must be repeated.
If the Brewer did not enter priming mode successfully, the 'HOT CHOCOLATE' and 'HOT WATER'
indicator lights will flash quickly in unison.
If this happens, switch off the Brewer and repeat steps 3-5 until the 'HOT WATER' indicator light is
on steadily.
The Brewer will not enter priming mode if the Pack Door is open or a freshpack has been inserted.
70
floz
(2,0L)
6
Note:
Before
priming your
Brewer ensure
that the Cold Tank
has been filled to
the "MAX" level.
Publicité
Chapitres
Table des Matières
