Installation Of Your Brewer; Electrical Supply - FLAVIA Creation 150 Manuel D'utilisation

INSTALLATION OF YOUR FLAVIA
BREWER DIMENSIONS
Height – 14.4" (365mm)

ELECTRICAL SUPPLY

It is important that you have a power supply ready so that we can install your new system quickly
and efficiently.
You will need to supply a suitably rated and protected (i.e. via RCD and/or MCB) incoming supply.
The Brewer must be connected to the supply via an earthed wall socket, ideally incorporating a
switch.
Please refer to the rating label on the Brewer for details of the supply voltage, frequency and
power rating required to operate the Brewer.
Use only one system per socket and ensure it is earthed.
Your system comes supplied with a mains lead, 69" (1.75m) in length. Only this lead should be
used, no old leads should be re-used.
Do not use extension cables; plug supplied mains lead directly into socket.
Note:
If you are unsure about any installation requirements, consult an electrician.
Width – 9.1" (231mm)
3
BREWER
®
Depth – 13.5" (344mm)