Preparing A Beverage/Drink - FLAVIA Creation 150 Manuel D'utilisation

PREPARING A BEVERAGE/DRINK

BREWING BEVERAGES
1.
Open the Pack Door by
turning the Grip Ring anti-
clockwise and insert your
chosen freshpack.
2
.
Close Pack Door by turning the
Grip Ring clockwise. Please note
that some resistance may be felt
as the Pack Door is closed. This is
normal; this step is "piercing" the
pack seal.
4
.
Press the drink
selection button
of your chosen
freshpack.
6
.
Turn the Grip Ring anti-clockwise to open the
Pack Door and remove the used freshpack for
disposal.
Take care when removing the pack
immediately after the brewing process as it
will be HOT.
After each vend, the boiler will heat water up the optimum temperature for the next drink to be
brewed. During this time the all the Indicator lights will flash slowly. There may be a short delay
before the next beverage can be brewed. When the Brewer is ready all the indicator lights will be
on steadily.
CAUTION:
• Do not open the Pack Door, attempt to remove the pack or press drink selection buttons
before brewing is complete, this will interrupt the brewing process.
• Pressing the drink selection button during brewing will interrupt the brewing process. The
Brewer will NOT complete an interrupted brew.
• Take care when removing the freshpack after an interupted brew as it will be HOT, and may
drip HOT water.
• Do not remove the Cold Tank from the product during brewing as this will reduce the
volume of the drink and subsequent drinks brewed.
3
.
Place a cup
centrally on the
Cup Stand and
push back until
it touches the
backstop.
5
.
When brewing is complete,
the indicator lights will
flash in an arrow pattern
to indicate that the used
freshpack should be removed.
8
Note: Always
use Grip Ring to
operate Pack Door