Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The sophisticated design of your FLAVIA® Brewer makes it unlikely that your Brewer will develop a fault.
However, if you are having trouble using your Brewer please refer to the table below for advice on how
to resolve problems for yourself. If your problem is not listed below please contact customer service.
PROBLEM
The Brewer does not operate.
The 5 Indicator Lights flash quickly.
The 'HOT CHOCOLATE' and 'HOT WATER'
Indicator Lights flash quickly in unison.
The Brewer will not enter the priming mode.
The 'HOT WATER' indicator light is on
steadily and the machine is not making any
noise.
The 5 Indicator Lights flash slowly.
The Brewer does not brew beverages after
pressing selection button.
The Brewer does not deliver hot water after
pressing and holding 'HOT WATER' button.
None of the Indicator Lights are illuminated.
The REGULAR and OVER ICE buttons
flash in an alternating pattern with the
CAPPUCINNO/LATTE button.
TROUBLE SHOOTING
SOLUTION
Check that the Plug is correctly inserted in to
the socket.
Check that the Power Switch is in the ON
position.
Check that the Cold Tank is correctly fitted
to the machine and/or filled to the "MAX"
indication line.
The Brewer has not been primed.
The Brewer must be primed with water
before using it for the first time.
Prime the Brewer by following the
instructions on page 6.
DO NOT switch the Brewer off during
priming. If the prime cycle is not completed
fully it must be re-started.
Ensure there is no pack inserted and that the
Pack Door is fully closed.
Follow the instructions carefully on page 6 to
enter the priming mode.
The priming or flush cycle has been paused.
Press the 'HOT WATER' button to resume the
priming cycle.
The Brewer is heating the water to the
optimum temperature for brewing; this may
take up to 90 seconds.
Ensure that the pack in inserted fully and that
the Pack Door is fully closed.
Ensure there is no pack inserted and that the
Pack Door is fully closed.
Check that the Plug is correctly inserted in to
the socket and that the Power Switch is in the
ON position.
If the Brewer has seen no activity for 120
minutes it will enter 'Power Save' mode.
To 'wake' the Brewer press any Selection
Button or open the Pack Door.
This is indicates that a pack inserted into the
Brewer must be removed. Remove the pack
to continue using the Brewer.
14
Publicité
Chapitres
Table des Matières
