Brewing A Cappuccino/Latte - FLAVIA Creation 150 Manuel D'utilisation

BREWING A CAPPUCCINO/LATTE

Cappuccino and Latte drinks are made using two packs, firstly a Cappuccino/Latte Swirl pack
followed by the coffee of your choice. It is important that the packs are placed in the correct
order. Please see the packs for further information.
1.
Open the Pack
Door by turning
the Grip Ring
anti-clockwise
and insert a
Cappuccino/Latte
Swirl pack.
3
.
Place a cup
centrally on the
Cup Stand and
push back until
it touches the
backstop.
5
.
After brewing the
Cappuccino/Latte swirl
pack the indicator lights
will flash in an arrow
pattern.
7.
Press the Cappuccino/Latte swirl drink
selection button and your drink will now be
freshly filtered and brewed into your cup.
HOT WATERFACILITY
With no freshpack in place, press and hold the 'HOT WATER' button. Hot water will begin to flow
whilst the button is pressed. Release the button to stop the water flow. The hot water dispense will
automatically stop after a maximum vend volume has been reached if the button is not released.
4.
Press the
Cappuccino/
Latte drink
selection
button.
6.
Open the Pack Door by turning the Grip Ring anti-clockwise and
remove the Cappuccino/Latte swirl pack. Insert a coffee freshpack
and close the Pack Door by turning the Grip Ring clockwise. Please
note that some resistance may be felt as the Pack Door is closed. This
is normal; this step is "piercing" the pack seal.
CAUTION:
Take care when
removing pack
immediately after
brewing as it will
be HOT.
2
Close Pack
Door by
turning he
Grip Ring
clockwise.
8.
When brewing is complete, Turn the Grip Ring
anti-clockwise to open the Pack Door and remove
the used freshpack for disposal.
9
.
Note:
Always use
Grip Ring to
operate Pack
Door.