Priming Your Brewer - FLAVIA Creation 200 Manuel D'utilisation

P R I M I N G Y O U R B R E W E R
BEVERAGES CAN NOT BE BREWED UNTIL THE BREWER HAS BEEN PRIMED
Note
If the Brewer is to be set for 'plumbed' operation refer first to the Section headed
CHANGING FROM 'MANUAL FILL' TO 'PLUMBED'
The 'Hot Water' button and 'CALL OPERATOR'
symbol on the top of the Brewer will now flash
70 oz
Note The priming cycle will be inhibited if the machine detects that a filterpack is inserted.
In this case the Insert/Remove Pack symbol
be removed. Lift the handle and remove the filterpack before continuing.
Step 3
Now Press the 'HOT WATER' button to begin the PRIME cycle.
The Brewer will start to pump water and after several seconds water will
be dispensed into the container. The water jet may be seen to 'splutter'
for a short while at the start, this is normal.
If needed, the Prime cycle can be paused and re-started by pressing the
'HOT WATER' button. The Brewer will automatically stop pumping after
about 2 minutes after which the Prime cycle is complete. The Brewer will
pump approximately 60 fl oz (1.7L) of water into the collecting container.
The system is now primed and will begin to heat the water. The 'PLEASE
WAIT' symbol will flash while the water heats. When complete the
'Drinks Selection' lights will illuminate
Your Brewer is now ready to start making drinks.
If your Brewer is set for 'plumbed' operation
your Brewer will automatically draw sufficient water from the supply. Please wait as this process may
take a few moments. Please do not fill your Brewer manually as this may automatically return your
machine to being set for 'manual fill'.
The priming cycle fills the boiler with water and flushes the system through.
After this your Brewer will be ready for use.
Step 1
Plug the Brewer into the AC outlet. Turn the switch on the back of the
Brewer to the 'ON' position. The 'ADD WATER`' symbol
the Brewer will flash.
If your Brewer is to be used in 'manual fill' operation
Lift the 'Filler Lid' on the top of the Brewer, and carefully fill with cold
drinking water to no higher than the 'MAX' level. It is important to fill to the
'MAX'level, on the first use, as this sets the brewer to 'MANUAL FILL'
operation.
Volume of water required for Initial Fill to 'MAX' level from empty.
With Filter Fitted
Without Filter Fitted
Step 2
Remove the drip tray from the Brewer and place a large
container of at least 70 oz (2.0L) under the drinks dispense
area.
= 110 fl oz (3.3L)
= 120 fl oz (3.6L)
will flash to indicate that the filterpack should
5
on the top of