Priming Your Brewer - FLAVIA Creation 150 Manuel D'utilisation

SETTING UP YOUR BREWER

PRIMING YOUR BREWER

Beverages cannot be brewed until the Brewer has been primed. The priming cycle fills the boiler
with water and flushes the system through. After this your Brewer will be ready for use.
Step 1:
Step 2:
and place a large container of at least
adjusted if necessary by pressing the button
or down.
Step 3:
Step 4: While continuing to hold down the two buttons
position.
Step 5: When the indicator lights of the two buttons being held illuminate,
Step 6:
Note:
Priming can be paused
seconds water will be dispensed into the container. The water jet may be seen to 'splutter' for a short
while at the start, this is normal.
The system is now primed and will begin to heat the water. While the water is heating, all this
indicator lights will flash slowly. When complete all the indicator lights will be on steadily.
Note:
The priming cycle will be paused if the machine detects that a freshpack is inserted, the Pack Door
is opened or the water level is low. Ensure that the Pack Door is closed and no freshpack is present
button.
indicator lights will flash quickly in unison.
on steadily.
70
floz
(2,0L)
6
Note:
priming your
that the Cold Tank