Water Filter Replacement - FLAVIA Creation 150 Manuel D'utilisation

Masquer les pouces Voir aussi pour Creation 150:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WATER FILTER REPLACEMENT

The recommended replacement frequency is approximately 1600 beverages or six months,
whichever comes first. Please contact Customer Service for details on how to order replacement
FLAVIA® Filters.
Step 1: Remove the Cold Tank Lid to access the Water Filter.
Remove the used filter by turning it counter-clockwise.
Step 2: Insert the replacement filter and rotate clockwise
to engage with the bayonet fitting inside the cold water
reservoir. Replace the Cold Tank Lid.
Step 3: The new filter will need to be 'Flushed'. Remove the Drip
Tray from the Brewer and place a large container in the dispense
area. Adjust Brew Head height if necessary by pressing the button
on the side of the Brew Head and sliding it up or down.
Step 4: Ensure that the Brewer is filled with water up to the
"MAX" level, to ensure that there is enough water in the Brewer to
complete the 'Flush' cycle.
Step 5: Turn the Brewer off then press and hold the 'HOT
CHOCOLATE' and 'HOT WATER' buttons.
Turn the Brewer back on whilst continuing to hold the
two buttons as the Brewer powers up.
When the indicator lights of the buttons being held down
illuminate, release them and the 'Hot Water' indicator
light will illuminate.
Step 6: Now Press the 'Hot Water' button to begin the FLUSH cycle. The
Brewer will start to pump water, and after several seconds water will be
dispensed into the container. The water jet may be seen to 'splutter' for a
short while at the start, this is normal.
Note:
The flush cycle can be paused and resumed by pressing the 'HOT WATER' button.
The Brewer will automatically stop pumping after about 2 minutes after which the Flush cycle
is complete. The Brewer will pump approximately 60 fl oz (1.7L) of water into the collecting
container.
The system is now flushed and will begin to heat the water. All the indicator lights will flash slowly
while the water heats. When complete all the indicator lights will be on steadily. Your Brewer is
now ready to continue making drinks.
12
70
floz
(2,0L)

Publicité

Chapitres

Table des Matières
loading

Table des Matières