Télécharger Imprimer la page

Minebea Intec YPS08-Y Manuel D'installation page 27

Publicité

Les langues disponibles

Les langues disponibles

Certificate No.:
IECEx FMG 20.0037X
Date of issue:
2023-03-10
EQUIPMENT:
Equipment and systems covered by this Certificate are as follows:
The YPS08-Y and YPS08-Z are power supplies for use with certified Weigh Indicators.
The power supply YPS08-Y is suitable for use inside the potentially explosive atmosphere.
The power supply YPS08-Z is only suitable for use outside the potentially explosive atmosphere.
Um = 240 Vac 50/60 Hz 5VA
Both Power Supplies provide non-linear intrinsically safe outputs of;
Um = 240V
Ci = 0 Co = 1.10 μH
Uo = 12.6 V
Li = 0
Lo = 41 μH
Io = 205 mA
Po = 2.6 W
Ambient temperatue range -10°C ≥ Ta ≥ 40°C
SPECIFIC CONDITIONS OF USE: YES as shown below:
1.
The protective ground connectors on the YPS08-Y (and YPS08-Z) and the Hazardous Location Weighing Terminal shall be connected
together using a potential equalization conductor with a cross-sectional area of at least 4 mm
2.
The Model YPS08-Y and YPS08-Z Power supplies do not withstand a 500Vrms dielectric strength test between the circuits and the earth
ground. This must be taken into account during installation.
3.
The cable glands used were tested for low risk of mechanical danger (drop height 0.4 m with 1 kg mass) and shall be protected against
higher impact energy levels.
IECEx Certificate
of Conformity
Page 3 of 4
Issue No: 2
2
.

Publicité

loading

Ce manuel est également adapté pour:

Yps08-z