Télécharger Imprimer la page

Minebea Intec YPS08-Y Manuel D'installation page 26

Publicité

Les langues disponibles

Les langues disponibles

Certificate No.:
IECEx FMG 20.0037X
Date of issue:
2023-03-10
Manufacturer:
Minebea Intec Bovenden GmbH & Co. KG
Leinetal 2, 37120 Bovenden
Germany
Manufacturing
locations:
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the
IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and
found to comply with the IECEx Quality system requirements.This certificate is granted subject to the conditions as set out in IECEx Scheme
Rules, IECEx 02 and Operational Documents as amended
STANDARDS :
The equipment and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found
to comply with the following standards
IEC 60079-0:2017
Explosive atmospheres - Part 0: Equipment - General requirements
Edition:7.0
IEC 60079-11:2011
Explosive atmospheres - Part 11: Equipment protection by intrinsic safety "i"
Edition:6.0
IEC 60079-18:2017
Explosive atmospheres - Part 18: Protection by encapsulation "m"
Edition:4.1
IEC 60079-31:2013
Explosive atmospheres - Part 31: Equipment dust ignition protection by enclosure "t"
Edition:2
This Certificate does not indicate compliance with safety and performance requirements
TEST & ASSESSMENT REPORTS:
A sample(s) of the equipment listed has successfully met the examination and test requirements as recorded in:
Test Reports:
US/FMG/ExTR19.0032/00
Quality Assessment Reports:
GB/FME/QAR13.0021/10
IECEx Certificate
of Conformity
other than those expressly included in the Standards listed above.
US/FMG/ExTR19.0032/01
GB/FME/QAR13.0021/11
Page 2 of 4
Issue No: 2
US/FMG/ExTR19.0032/02

Publicité

loading

Ce manuel est également adapté pour:

Yps08-z