Mitel 5550 IP Console Guide D'installation page 18

10. Execute the software by following one of the steps below:
• Insert the 5550 IP Console software disk that you created in
step 9 in the CD-ROM.
• Unzip the software file you downloaded in Step 7 and execute
the install process.
11. Follow the on-screen instructions to complete the installation.
IMPORTANT: To launch the console without administrative
!
privileges, DO NOT install it in the default folder, C:\Program
Files\Mitel. Instead, install in a folder such as C:\5550ip. Select
the same folder as the destination for files associated with the
Bulletin Board and BLF features. To allow access to these files
from multiple consoles, locate them on a shared network drive.
When installation is complete, the Configuration Wizard starts.
The wizard is used to register the console with the MCD.
NOTE: Accept the default location for the files and folders when
installing the 5550 IP Console software on Windows Vista.
You will need to:
-
-
-
-
NOTE: The Configuration Wizard can be run again to correct
errors, or following changes to information previously entered, by
clicking the Windows Start button and choosing > All Programs >
Mitel > 5550 IP Console > Tools > Configuration Wizard.
12. Reboot the PC after installation is complete.
10
OR
enter the IP address or host name of the controller, and the
MAC address of the console keypad (the address is on the
bottom of the keypad.)
specify the location and names of the database mapping
files, as well as the location for the Comments file (only if
you are enabling the Additional Database Fields (ADF)
feature). For more information, refer to the 5550 IP Console
Help.
Note: You must enable ADF if you wish to enable User
Messaging.
specify the location of the Messages folder (if you wish to
enable the User Messaging feature). For more information,
refer to the 5550 IP Console Help.
enter the Set Registration access code and the directory
number of the console unless already programmed on the
MCD.
English