Animal Weighing And Stable Detection - MS Schippers 4309606 Mode D'emploi

Press key to return to normal mode from counting mode.

7. Animal Weighing and stable detection

Drive the animal on to the platform. If the weight stabilises within a few seconds, the weight is
stored.
If the weight now changes, the new weight is recorded and stored.
Animal weighing mode can be switched on or off by setting the parameters.
To set stable detection, switch on the scale.

Press the key during the start-up procedure.

The display shows

Press ,

Press until display shows
 Press
key to confirm and then press

If necessary, use the
with . When the setting is
Rag

Display shows
confirm with

RAG: Set the number of parts* in which the stable weight is determined compared with the
average weight recorded. Setting options: 1-2-5-10-15-20-25 and 50.
See explanation on setting of parts at the bottom of this page.
Assume 1 part of 0.5 kg has been chosen and 5 is selected here: the range is 2.5 kg
(5 x 0.5 kg) from the average weight recorded.
The higher the number of parts is set, the faster the stable weight is determined but the
more inaccurate the weighing.
Tim

Display shows
confirm with

TIM: Set the number of times that the weight must have been in the range (RAG) to lock a
stable weight. 10-20-30-40-50-60-70-80-90.
The higher the TIM, the longer it takes to determine the stable weight but the more
accurate the weighing.
28
pn
and , display shows
p4 oth
key to select until the display shows
On
, stable detection is in use.
with set values. If necessary, adjust these using the
.
with set values. If necessary, adjust these using the
.
poch
Ani
to select
On
and confirm again
key and
key and