Tare; Setting A Reference Weight; Check Weighing; Explanation - MS Schippers 4309606 Mode D'emploi

3.2 Tare

Reset the scale to zero by pressing the
Place a box or crate on the platform. This weight appears on the display.
Press the key to set the tare weight. The weight displayed is stored as the tare weight, which
is substracted from the display. The display shows 0 and the NET indicator appears. If a product is
now weighed, only that weight is displayed. A second tare weight can be set, for example if
another type of product is added. Again, only the weight of the added product is shown on the
display.
If the box or crate is removed, a negative weight is displayed. If TARE is pressed just before
removing the box, the gross weight is displayed (= box + products). The ZERO indicator appears
because the scale is in the same state as when the

3.3 Setting a reference weight

To set a reference weight, tare the empty box first and then place the product in the box. The
display shows the weight and the number of products present.

4. Check Weighing

4.1 Explanation

In check weighing, an alarm or beep sounds when the weight on the scale reaches or exceeds the
value set in the memory. The memory stores an upper (high) and a lower (low) limit.
Check mode: OK
During check weighing, OK appears on the display and the beep sounds if the weight is within the
two limits.
Check mode: NG (not good)
During check weighing, NG appears on the display and the beep sounds if the weight is outside
the two limits.

4.2 Set Limits

Press and key together, display will show "set h".
Press key to select "set h" or "set l".
Press key to confirm, display will show 00000 and the last digit will blink.
Enter the high limit value by using
key to increment the value.
key if necessary. The ZERO indicator appears.
key was last pressed.
and keys to change the active digits and press
25