Chamberlain WPD60UP-05 Notice De Montage Et De Commande page 45

Setting end stops
Set the bottom end stop
1.
press + hold
The roller shutter
moves down
2.
press + hold
You can now release
3.
the DOWN button, the
shutter continues to
move down.
4.
Release the Set button
as soon as the desired
position for the bottom
end stop is reached.
The display shows:
:
I 2:0 0
A UTO
The icon of the current travel direc-
tion appears in the display.
Note
The Set button lies slightly re-
cessed into the cover. Please use
a small pin or something similar
to press the Set button.
The roller shutter stops, the
bottom end stop is now saved.
The standard display appears.
Note
Make sure when setting the bottom
end stop that the Set button is
immediately released when the roller
shutter is closed and the webbing no
longer runs up. The electronic system of
the drive monitors the rotation of the
pulley and could switch off the drive
when the pulley becomes stationary
before you release the Set button (see
page 25).
Changing end stops
Move the roller shutter into the centre
position and reset the respective end
stop as described here.
17