Dismantling The Roller Shutter Drive - Chamberlain WPD60UP-05 Notice De Montage Et De Commande

Dismantle the roller shutter drive
If you need to remove the roller
shutter drive due to relocation or
renovation, proceed as follows:
Press the DOWN button and close
1.
the roller shutter completely.
Press for about 8 seconds the but
2.
tons UP, DOWN and SET simultane
ously so that you delete all the set
tings including the end stops (see
page 22).
Press the (t) DOWN button and keep
3.
it pressed.
Now pull the webbing from the unit
4.
by hand using the pulley as far as
possible to the front.
R e m o v e t h e c o v e r p l u g .
5.
By pressing lightly on its lower half,
the cover plug tilts slightly from its
holder.
Loosen the mounting screws and
6.
pull the roller shutter drive from
the belt box.
Remove the webbing cover.
7.
8.
Then check the position of the
mounting hook so that you can
easily remove the webbing.
Note
If necessary, move the hook into
the correct position to remove the
webbing.
Risk of injury through
the winding wheel, if
you reach into the
mounting hole with
the motor running.
Pull out the power plug before you
reach into the mounting hole.
9. Loosen the webbing from the
mounting hooks of the winding
wheel
25