Preparing Hot Water - Melitta PASSIONE Mode D'emploi

Rinsing the Cappuccinatore
1. Fill a vessel with clear water.
2. Immerse the milk hose in the filled vessel.
3. Place an empty vessel beneath the Cappuccinatore.
4. Press the "Steam dispensing" button.
» The flashing display indicates that the appliance is heating up for
steam dispensing.
» The lit-up display than indicates that steam dispensing is ready.
5. Turn the selector switch of the Cappuccinatore until the setting for milk
foam points upwards.
6. Turn the rotary regulator clockwise up to the stop.
7. Turn the rotary regulator anti-clockwise up to the stop as soon as a
clean water/steam mixture flows into the empty vessel.
» The Cappuccinatore is rinsed.
Information
We recommend:
ū Not only rinsing the Cappuccinatore, but dismantling and cleaning
it at regular intervals (see section 7.3 Cleaning the Cappuccinatore on
page 84).
ū Rinsing the Cappuccinatore each week with the Melitta® PERFECT
CLEAN milk system cleaning agent for fully automatic coffee makers.
Use the milk system cleaning solution instead of fresh water.
5.7

Preparing hot water

Prepare hot water on the Cappuccinatore.
CAUTION
Hot water and hot steam flowing out of the pipe
Do not touch the steam pipe during and immediately after use.
ƒ
Wait until the steam pipe has cooled down.
ƒ
Requirement: The appliance is ready for operation. The Cappuccinatore is
connected.
1. Place a vessel beneath the Cappuccinatore.
2. Turn the selector switch of the Cappuccinatore until the setting for hot
water points upwards.
3. Turn the rotary regulator clockwise.
» Beverage dispensing starts.
Preparing beverages
75