Titan MAXI II Notice D'instructions page 28

6.3. Operating the unit
Strapping the steel band
The steel band is routed from the
uncoiled through the locking sleeve
around the packing item and again
through the sleeve.
Bending the beginning of band
The beginning of band is routed through
the locking sleeve, approx. 4-5 cm, then
it is bent sharply below the sleeve.
The loop resulting that way is pulled tight
manually. The bent beginning of band
must in any case be in contact with
the packing item to be strapped.
Apply the unit
Hold the steel band being on top with
your left hand. Press lifting lever and
compressed air motor with your
right hand. Slip the band below the
tension wheel and then forward to the
locking sleeve.
Lower compressed air motor.
MAXI II
28 / 55
H 263 EU 22/08