Publicité
Les langues disponibles
Les langues disponibles
Attaching
the ice maker
to a water
supply
Read all directions
carefully
before
you begin.
Electrical Shock Hazard
. Disconnect electrical supply to refrigerator
before installing.
l
Electrical drill must be grounded before drilling
holes in water line.
Failure to do so couki result in electriil
shock,
serious injury, or death.
IMPORTANT:
l
Use copper tubing only and check for leaks.
l
Install ice maker tubing in areas where temperatures
are above freezing.
Tools
required:
l
Standard screwdriver
l
7/is-inch and S-inch open-end wrenches or
2 adjustable wrenches
l
G-rch
nut driver
l
Winch drill bit
l
Hand drill or electric drill (properly grounded)
NOTE: Your nearest appliance dealer has a kii
available with a X-inch saddle type shut-off valve, a
union, and copper tubing. Before purchasing,
make
sure a saddle type valve complies with your local
plumbing codes. Do not use piercing type or %s-inch
saddle valve which reduces water flow and clogs
more easily.
Cold
water
supply
Ice maker water valve wntains
a flow washer which is
used as a water pressure regulator. The ice maker
needs to be connected to a cold water line with water
pressure limitations of 20-120 psi. If a problem occurs,
call your utility company.
IMPORTANT:
. It may take up to 24 hours for your ice maker to
begin producing ice.
l
If operating the refrigerator before installing the water
connection,
turn ice maker to the OFF position to
prevent operation without water.
l
All installations
must be in accordance with local
plumbing code requirements.
I
INSTALLATiON IS NOT WARRANTED
BY REFRIGERATOR OR ICE MAKER
MANUFACTURER.
I
9
Publicité
