Broan-NuTone CLDA1 Serie Manuel D'installation, D'utilisation Et D'entretien page 9

Prepare the Hood
1 ] If present, remove all protective polyfilm from the hood and/or parts .
2 ] Using the finger cup (CLDA1 Series) or the tab (CLSC2 Series), remove the grease filters
from the hood by pushing down
B
HD0842
3 ] Remove the EZ1 brackets from inside the hood by cutting off the tie wrap (no EZ1 brackets
in CLSC2 Series) . Remove both screws holding damper assembly to hood . Remove parts
bag (captured behind the damper assembly) . Remove damper assembly from inside the
hood and keep the screws for further use .
EZ1
BRACKETS
4 ] Remove the wiring cover (shaded part on illustration below) by sliding it out from the hood
and set it aside .

and tilting filters out
C
HD0843
HD0844

.
SCR EWS
DAMPER
ASSEMBLY
9