Broan-NuTone CLDA1 Serie Manuel D'installation, D'utilisation Et D'entretien page 13

4 ] Drill a 1/8" dia . pilot hole for house wiring, at A location on template .
5 ] Use a sharp pencil or 1/8" drill bit to mark the locations for the appropriate duct access
holes (16 locations for 7" round duct, or 4 corner locations for rectangular duct) . Remove the
template .
6 ] Draw the border for the exhaust ducting by linking its marks (16 for round duct and 4 for
rectangular duct), then cut the opening in the cabinet bottom (vertical exhaust) or in the wall
(horizontal exhaust) . Drill the house wiring hole by using a 1½" hole saw centered with the
pilot hole previously made in 4 .
7 ] Install the proper installation brackets according to the type of cabinet (framed or frameless) .
See below .
FRAMED CABINET
Refer to the marking on the brackets to determine the correct installation side and
HA0113
orientation .



Mate the corresponding bracket to the cabinet side frame, while placing rear end
of bracket against the wall . Use a pencil to mark 3 holes (there are 6 holes but only
HR0107A
3 are necessary) .

Remove the bracket . Using a 7/64" drill bit, drill 3 holes where marked .

Assemble the bracket to the side frame using a Phillips screwdriver and 3 provided
no . 8 x 5/8" wood screws . Repeat for the other side frame .

7/64"
13