Broan-NuTone CLDA1 Serie Manuel D'installation, D'utilisation Et D'entretien page 14

FRAMELESS CABINET
HR0108A
14
HA0114
Refer to the marking on brackets to determine the correct installation side and orientation .

3 X

7/64"

Align the corresponding bracket to the cabinet side, while placing rear end of bracket
against the wall . Draw a line on the outer edge of the bracket (as shown) .

Slide the bracket towards the center of cabinet and align the outside edge of the
bracket with the marked line, keeping the rear end edge leaning on the wall .

Use a pencil to mark 3 holes .

Remove the bracket . Using a 7/64" drill bit, drill 3 holes where marked .

Assemble the bracket to the cabinet bottom using a Phillips screwdriver and 3 provided
countersunk wood screws . Repeat for the other cabinet side .


