Broan-NuTone CLDA1 Serie Manuel D'installation, D'utilisation Et D'entretien page 18

1 ] Run house power cable between service panel and hood location . Run the house power
2 ] Hang hood from (4) mounting screws previously installed . Slide hood back towards wall until
3 ] Connect ductwork to hood and use metal foil duct tape to make joints secure and air-tight .
18
Install the Hood (Standard Installation)
cable into the hood through the strain relief previously installed in step 6 on page 10 .
mounting screw heads are engaged in narrow end of keyhole slots in top of hood . Tighten
screws securely . Attach power cable to the hood using the strain relief .
HD0848
DUCTED INSTALLATION ONLY
Make sure the damper assembly (or round duct plate) enters the ductwork and that the damper
opens and closes freely .