Publicité
Les langues disponibles
Les langues disponibles
3 INSTALLATION
3.1 UNPACKING
Perform the unpacking operations as indicated by the images in Section 6 (Illustrations).
Respect the following general indications:
•
It is advisable to open the packaging as close to the final location as possible.
•
Use a proper tool to open the packaging. Do not insert the blade too deep to avoid damaging the
contents.
•
Keep all the packaging elements for any future transport operations.
•
Do not wear any watches, bracelets, rings, etc., in order to avoid scratching the loudspeakers and their
finishes. The same care must be taken in order to protect the loudspeakers from any metal elements
present on the clothes you are wearing, such as zippers, buttons, belt clasps, rivets, etc.
•
Check the content of the packaging (see Section 6 - Technical Specifications). If one or more of the
items is missing, notify the dealer where the product was purchased.
•
Do not touch the drivers during the operation.
Hold the loudspeaker securely with both hands in order to avoid dropping it. Depending on
the weight of the loudspeaker, the indicated operations can be performed more safely and
conveniently by two people.
The packaging materials can cause pollution.
These materials must not be disposed of as domestic waste and must be brought to a waste
collection and recycling center.
Do not leave the packaging materials within the reach of children!
They could pose a risk of poisoning or suffocation if ingested.
Some loudspeakers can be fitted with a thread-tensioning mask, to be found in the accessories kit.
Refer to Section 6 (Illustrations) and carefully follow these instructions:
•
Insert the pins of the bars of the string grille in the relevant guides, starting from the bottom of the
speaker.
•
Stretch the elastic bands of the mask until you are able to insert the pins of the mask bars into the
relevant guides in the upper part of the speaker.
If you wish to disassemble the string grille, first pull the bar pins out starting from the top of the speaker,
then move to the base.
While mounting or removing the thread-tensioning mask as described above, be careful not to
damage the front part of the speaker.
3.2 ASSEMBLY
Carefully refer to the drawings in Section 6 (Illustrations).
15
15
EN
IT
Publicité
