Cleaning And Maintenance; Defects And Malfunctions; Transport And Storage; Additional Information - Tunturi C50 Cross trainer Manuel De L'utilisateur

‼ NOTE
• Tunturi only provides the option to connect
your fintess console throughout a blue tooth
connection. Therefore Tunturi cannot be held
resposible for damage, or malfunctioning of
products other than Tunturi products.
• Check the website for extra information.
This console can receive a Bluetooth heart-rate
transmitter. There is no need to pair the device, as the
console will auto detect the heart-rate transmitter when
it is in range.

Cleaning and maintenance

The equipment does not require special maintenance.
The equipment does not require recalibration when
it is assembled, used and serviced according to the
instructions.
⚠ WARNING
• Do not use solvents to clean the equipment.
- Clean the equipment with a soft, absorbent cloth
after each use.
- Regularly check that all screws and nuts
are tight.
- If necessary, lubricate the joints.

Defects and malfunctions

Despite continuous quality control, defects and
malfunctions caused by individual components may
occur in the equipment. In most cases it's unnecessary
to take the whole device in for repair, as it's usually
sufficient to replace the defective part.
If the equipment does not function properly during use,
contact your Tunturi dealer immediately. Always give
the model and serial number of your equipment. Please
state also the nature of the problem, conditions of use
and purchase date.
If you require spare parts, always give the model, serial
number of your equipment and the spare part number
for the part you need. The spare part list is at the back
of this manual. Use only spare parts mentioned in the
spare part list.
Trouble shooting:
- If there is no signal when you pedal, please check if
the cable is well connected.
‼ NOTE
• When stop training for 4 minutes, the main
screen will be off.
• If the computer displays abnormally, please re-
install the transformer and try again.
Squeaking rollers
- Regular Usage: Apply 2cc. of the lubricant on each
protruding rail surface every three months.
- When sliding wheels are making noise during
sliding movement, apply 2cc. of lubricant on each
protruding rail surface immediately.
⚠ CAUTION
• We recommend to use a silicon based lubricant.
• Do not apply too much lubricant or wipe off
redundant lubricant with a clean cloth as too
much lubricant can cause carpet stain or dirt
particle.
Shaky or unstable feeling during use
If the machine feels unstable or unstable during
operation, it is advisable to adjust the support feet
to bring the frame to the correct height. Read the
instructions in this manual in section: "Use"

Transport and storage

⚠ WARNING
• Carry and move the equipment with at least two
persons.
- Remain standing in front of the equipment on each
side and take a sturdy grip at the handlebars. Tilt
the front of the equipment so as to lift the rear of
the equipment on the wheels. Move the equipment
and carefully put the equipment down. Place the
equipment on a protective base to prevent damage
to the floor surface.
- Move the equipment carefully over uneven surfaces.
Do not move the equipment upstairs using the
wheels, but carry the equipment by the handlebars.
- Store the equipment in a dry place with as little
temperature variation as possible.

Additional information

Packaging disposal
Government guidelines ask that we reduce the amount
of waste material disposed of in land fill sites. We
therefore ask that you dispose of all packaging waste
responsibly at public recycling centres.
End of life disposal
We at Tunturi hope you enjoy many years of enjoyable
use from your fitness trainer. However, a time will come
when your fitness trainer will come to the end of its
useful life. Under 'European WEEE Legislation you are
responsible for the appropriate disposal of your fitness
trainer to a recognised public collection facility.
2 5
English